Precautions for use of gear reducer
release time:
2022-02-15
The machine shaft should be cleaned before use. And check whether the equipment shaft has bruises and dirt, and if there are any, they should be eradicated. Check whether the writing specification of the hole (or shaft) connected to the reducer meets the requirements. The tolerance of the hole should be H7 (the tolerance of the shaft is H6).
1. Precautions before assembly of reducer:
1. The shaft of the machine should be cleaned before use. And check whether the equipment shaft has bruises and dirt, and if there are any, they should be eradicated.
2. The operating temperature of the reducer is 0-40 ℃.
3. Check whether the writing specification of the hole (or shaft) connected to the reducer meets the requirements. The tolerance of the hole should be H7 (the tolerance of the shaft is H6).
4. Before use, replace the blockage at the highest position with an exhaust plug to ensure that the gas in the body is discharged when the reducer is running.
Second, reducer equipment
1. The intelligent equipment of the reducer is on a flat, shock-absorbing, torsion-resistant support structure.
2. Under no circumstances is it allowed to hammer pulleys, couplings, pinions or sprockets, etc. into the output shaft with a hammer, as this will damage the bearings and shaft.
3. Use and protection
1. After the reducer is installed, check whether it is sensitive. For formal use, it is necessary to carry out no-load test, and then gradually load the operation when the operation is normal.
2. The reducer cannot be overloaded.
3. Before using the reducer and during operation, check whether the oil level is normal.
Related news
Kexin can customize various non-standard special high-precision spiral bevel gears and hard-toothed cylindrical gears according to customer needs
Hebei Kexin Gear Co., Ltd.
Sales Department.: +8617531190369
Email: kexin@lxc.cn
Address: Renmin Village, Fanzhuang Town, Zhao County, Shijiazhuang City, Hebei Province
Copyright © 2022 Hebei Kexin Gear Co., Ltd.